Filter
Top Products
Model G5353 Spray Gun-8-
1. Fluid Control: Controls the volume of
material that travels through the fluid
tip.
2. Pattern Control: Adjusts the spray
pattern from a round pattern to a wide
fan.
3. Atomizing Cap: Controls the spray
pattern from vertical to horizontal.
4. Trigger: Two stage trigger. Stage
one only releases compressed air for
blowing off the work piece. Stage two
sprays material. Lightly squeeze the
trigger for stage one. Squeeze the
trigger all the way to spray.
Figure 4. Controls.
Pattern Control
Atomizing Cap
Trigger
Controls
3. Attach the air hose to the directly to
the air fitting on the spray gun or with
a
1
⁄4" NPS quick connect fitting (not
included).
4. Attach the spray gun to a filtered, regu-
lated air source. See the Tool Data
Sheet on Page 6 for your spray gun air
requirements.
Note: For the best results, use a hose
that will be dedicated for spray use
only. Do not use a hose that has been
used with an in-line oiler or other pos-
sible contaminant.
If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.
Figure 3. Installing cup.
2. The cup is removed/installed by loos-
ening/tighting the cup lock and engag-
ing/disengaging the hooks to the cup
pins (see Figure 3).
Fluid Control
Cup Lock