Filter
Top Products
G5979 Wood Lathe -13-
The headstock can be locked into position using
the supplied locking handle. To install this handle:
1. Locate the handle, spring and special screw.
2. Slide the spring over the special screw. Push
the screw through the locking handle and
thread it into the locking clamp located on the
side of the headstock.
3. The locking handle is designed so that it can
be tightened down and then turned out of the
way of the operator. To tighten down the
handle, push in and turn clockwise.
Releasing the handle will disengage the
threaded shaft, allowing you to reposition the
lever handle out of the way. To release the
lock handle, push it in and turn counterclock-
wise.
Headstock Lock
Figure 7. Attaching the headstock lock handle.
2. Press it into the headstock spindle.
To remove the spur center:
1. Insert the push-out rod into the headstock
spindle hole opposite the end of the spur cen-
ter.
2. A firm push should release the spur center.
You may have to tap on the end of the push
rod with a rubber mallet. Be sure to hold the
spur center before releasing it so it will not fall
on the floor.
The spur center is a M.T. #2. To install the spur
center:
1. Make certain the spur center is clean and free
of dirt or grease.
Spur Center
Figure 8. Installing the spur center.
Figure 9. Removing the spur center.