Filter
Top Products
Always disconnect air from nailer
whenever clearing a jammed nail!
G6045/G6046/G6047 18 Gauge Brad Nailer
-8-
To clear a jammed nail from the discharge
area on the Model G6046:
1. Disconnect the nailer from the air
supply! Remove all brad nails from
the magazine.
2. Loosen the 2 cap screws that secure
the driver guide cover to the driver
guide on the nose assembly. Slide the
driver guide cover toward the nose
and pull it over the 2 cap screws. See
Figure 6 to identify these parts.
3. The jammed nail should now be visi-
ble; remove it with needle nose pliers.
4. Install the guide cover and check the
safety yoke mechanism for proper
operation (following the same instruc-
tions as mentioned in the Safety sec-
tion).
Figure 6. Removing guide cover.
Cap Screws
Guide Cover
Clearing Jammed Nails
The most frequent situation with any type
of nailer is a nail jam. A jammed nail must
be cleared before using the nailer again.
The two places where a nail can get
jammed are the magazine and the dis-
charge area.
Figure 5. Removing guide cover.
Quick Release Latch
6. Replace the driver guide cover and
snap the quick release latch back into
operating position.
To clear a jammed nail from the magazine:
1. Disconnect the nailer from the air
supply!
2. Open the magazine cover and pull the
magazine all the way back.
3. Locate and remove the jammed brad
nail with a pair of needle nose pliers.
Close the magazine cover so it latch-
es.
To clear a jammed nail from the discharge
area with the Model G6045/G6047:
1. Disconnect the nailer from the air
supply!
2. Remove all of the brad nails from the
magazine.
3. Flip up the quick release latch that is
located on top of the nailer nose
assembly as shown in Figure 5.
4. Remove the driver guide cover.
5. The jammed nail should now be visi-
ble; remove it from the discharge area
with needle nose pliers.
Driver Guide Cover