Grizzly G9979 Saw User Manual


  Open as PDF
of 72
 



5.        
Figure 54
6.         
        

Note: Make small adjustments to the set
screws, then recheck the alignment of the
table with the blade.
7.         
  


Blade Guides/
Support




Adjusting Blade
GuidesPage 31

Figure 55
Tungsten Steel
Inserts
Swap &
Turn Over
Rotate
Blade Support
Wear
Mark
Figure 55.
        
      
        



Figure 55
Note: Make sure to re-adjust the blade guides
and support as directed in Adjusting Blade
Guides on Page 31 after making these changes.
Figure 54. 




 previous next