Filter
Top Products
G8595 14.4V Cordless Drill-7-
OPERATION
Inserting Battery Into Drill
1. Insert the battery into the handle of
the drill so that the long end is for-
ward. The battery will only install in
one orientation.
2. Make sure the securing clasps on
either side of the drill base engage
with the clips on the battery compart-
ment.
Inserting and Removing Bits and
Drivers:
1. Set the direction switch, located just
above the trigger, so that it is in the
center locked position.
2. Hold the chuck by the collar while
turning the sleeve (the forward sec-
tion). This will cause the three chuck
jaws located inside the recess to
open or close depending upon the
direction.
3. When the jaws are at the approximate
diameter of the bit or driver, insert the
shank end of the bit or driver into the
jaw opening.
4. Turn the sleeve clockwise until it tight-
ens around the bit or driver. Never
“power tighten” which is holding the
sleeve while running the drill. This
can cause a loose grip on the bit or
driver and potential damage to chuck
jaws. Check for tightness periodically
while using the tool.
5. To release the bit or driver, hold the
chuck collar, and turn the sleeve
counterclockwise.
Operating this equipment has the
potential to propel debris into the air
which can cause eye injury. Always
wear safety glasses or goggles when
operating equipment. Be certain the
safety glasses you wear meet the
appropriate standards of the
American National Standards
Institute (ANSI).
Fig 2. Inserting bits into the chuck.