Filter
Top Products
Tools Needed Qty
To replace the motor brushes:
1.
2. Figures
38 & 44
Replacing Motor
Brushes
Figure 38.
Adjusting Gibs
Figure 37
NOTICE
When adjusting gibs, keep in mind that
the goal of gib adjustment is to remove
unnecessary movement from the slides
without causing them to bind. Loose gibs
may cause poor finishes on the workpiece
and undue wear on the slide, nut and lead
screw. Over tightening will make turning
the handwheel difficult.
Tools Needed Qty
To perform this procedure for the cross-slide
gib and the compound-slide gib:
1.
2.
3.
4.
3.
4.
Figure 37.