Filter
Top Products
G8694/G8695/G8889 Air Compressors
-5-
110V Operation
CIRCUIT REQUIREMENTS
If you find it necessary to use an extension cord
with your compressor, make sure the cord is
rated Hard Service (grade S) or better. Refer to
the chart in the standard safety instructions to
determine the minimum gauge for the extension
cord. The extension cord must also contain a
ground wire and plug pin. Always repair or
replace extension cords when they become worn
or damaged.
Extension Cords
Grounding
This equipment must be grounded. Verify
that any existing electrical outlet and circuit
you intend to plug into is actually ground-
ed. If it is not, it will be necessary to run a
separate 12 A.W.G. copper grounding wire
from the outlet to a known ground. Under
no circumstances should the grounding pin
from any three-pronged plug be removed.
Serious injury may occur.
In the event of an electrical short, grounding
reduces the risk of electric shock by providing a
path of least resistance to disperse electric cur-
rent. These machines are equipped with power
cords having an equipment-grounding conductor.
See Figure 1. The outlet must be properly
installed and grounded in accordance with all
local codes and ordinances.
These air compressors are wired for 110/120V,
single phase operation only. The chart below
shows the maximum amperage draw and recom-
mended fusing level for each of the machines.
Figure 1. Grounded plug configuration.
G8694
G8695
G8889
2.0
2.5
2.0
12
17
12
15
20
15
Model
Amperage
HP
Max
Fuse
It is generally best to operate a compressor on a
dedicated circuit, i.e. a circuit where there are no
other electrical appliances plugged in. The fuse
requirements above assume the use of a circuit
breaker or a slow-blow fuse. If an unusual load
does not exist and the compressor still breaks the
circuit, contact a qualified electrician or our ser-
vice department.