Grizzly G9036 Lathe User Manual


  Open as PDF
of 100
 
"'-"
<.%(+&(M)%<ZVg"=ZVYAVi]Z
Figure 34.>chZgi^c\VYZVYXZciZg^cViV^ahidX`#
Figure 33.Ine^XVa[VXZeaViZVcYYZVYXZciZg
hZije#
Mounting Center in Tailstock
1. ;ZZYi]Zfj^aadjiVWdji&hdi]Vii]ZXZciZg
XVcWZ^chZgiZY#
2. >chZgi i]ZXZciZg^cid i]Zfj^aadeZc^c\ hZZ
Figure 34#
L]Zc VXZciZg ^h jhZY^c i]Zhe^cYaZ! i]Zbdhi
Xdbbdc Veea^XVi^dc ^h jh^c\ ^i l^i] V [VXZeaViZ
hZZFigure 33#
3. Edh^i^dc i]Z iV^ahidX`hd i]ZXZciZg egZhhZh
V\V^chii]Zldg`e^ZXZ!i]ZcadX`i]ZiV^ahidX`
^ceaVXZ#
4. ;ZZYi]Zfj^aa^cidi]Zldg`e^ZXZ#I]Z[dgXZ
d[VbdjciZYldg`e^ZXZl^aa[jaanhZVii]Z
iVeZg#
Note: Make sure there is a center drilled hole
in the end of the workpiece for the center.
5. AdX`i]Zfj^aa^cideaVXZdcXZi]ZXZciZgVcY
i]ZeVgigdiViZid\Zi]Zg#I]Zfj^aabVncZZY
idWZVY_jhiZYYjg^c\deZgVi^dc#
6. IdgZbdkZVXZciZg!gZigVXii]Zfj^aajci^ai]Z
XZciZgedeh[gZZ#7ZhjgZidXViX]^il]Zc^i
XdbZhdjiidVkd^YYVbV\^c\i]Zi^e#
Mounting Center in Spindle
1. GZbdkZi]ZX]jX`[gdbi]Zhe^cYaZ#
2. >chiVaai]ZYZVYXZciZg^ci]Zhe^cYaZhaZZkZ#
3. >chiVaai]ZhaZZkZ^cidi]Zhe^cYaZdeZc^c\#
4. 6iiVX]i]Z[VXZeaViZidi]Zhe^cYaZ#
Note: When using the dead center in the
spindle, use a lathe dog so that your part will
rotate with the spindle and not spin on the
dead center tip.
 previous next