Filter
Top Products
G9928 Flex Shaft Grinder
-2-
10. WEAR PROPER APPAREL. Do not
wear loose clothing, gloves, neck-
ties, rings, bracelets, or other jewel-
ry which may get caught in moving
parts. Non-slip footwear is recom-
mended. Wear protective hair cover-
ing to contain long hair.
11. ALWAYS USE SAFETY GLASSES.
Also use face or dust mask if cutting
operation is dusty. Everyday eye-
glasses only have impact resistant
lenses, they are NOT safety glass-
es.
12. WEAR APPROVED HEARING
PROTECTION.
13. SECURE WORK. Use clamps or a
vise to hold work when practical. It is
safer than using your hand and frees
both hands to operate tool.
14. DO NOT OVERREACH. Keep prop-
er footing and balance at all times.
15. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for best
and safest performance. Follow
instructions for lubricating and
changing accessories.
16. REDUCE THE RISK OF UNINTEN-
TIONAL STARTING. Make sure
switch is in off position before plug-
ging in.
17. DISCONNECT TOOLS before ser-
vicing and changing accessories.
18. USE THE RECOMMENDED
ACCESSORIES. Consult the
owner’s manual for recommended
accessories. The use of improper
accessories may cause risk of injury.
19. CHECK DAMAGED PARTS. Before
further use of the tool, a guard or
other part that is damaged should be
carefully checked to determine that it
will operate properly and perform its
intended function. Check for align-
ment of moving parts, binding of
moving parts, breakage of parts,
mounting, and any other conditions
that may affect its operation. A guard
or other part that is damaged should
be properly repaired or replaced.
20. NEVER ALLOW UNTRAINED
USERS TO RUN THIS TOOL
WHILE UNSUPERVISED.
21. IF YOU ARE UNSURE OF THE
INTENDED OPERATION, STOP
USING THE TOOL.
22. DO NOT BEND SHAFT MORE
THAN 90 DEGREES. Make sure the
Flexible Shaft (P9928021) is not
bent more than a 90 degree angle.
If the Flexible Shaft is kinked or
crimped, it could cause inefficient
grinder operation and create a safe-
ty hazard. Note: Performance of the
Flexible Shaft Grinder may vary
depending on local line voltage or
use of an extension cord.
Safety Instructions For Power Tools