Filter
Top Products
Dust Collection
DO NOT operate the Model G0739 without an
adequate dust collection system. This sand-
er creates substantial amounts of wood dust
while operating. Failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Recommended CFM at Dust Port: 100 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Power Connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
Connecting Power
Figure 9.
1. TurnthemachinepowerswitchOFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
nowconnectedtothepowersource.
Disconnecting Power
Figure 10. Disconnect power.
1. TurnthemachinepowerswitchOFF.
2. Graspthemoldedplugandpullitcompletely
outofthereceptacle.Donotpullbythecord
asthismaydamagethewiresinside.
Figure 8.
To connect a dust collection hose:
1.
Figure 8
2.