Filter
Top Products
H0599 18V Cordless Cutting Tool
-5-
Getting Started
Using Your Tool
OPERATIONS
Like all power tools, there is danger
associated with the Model H0599.
Accidents are frequently caused by
lack of familiarity or failure to pay
attention. Use this tool with respect
and caution to lessen the possibility of
operator injury. If normal safety pre-
cautions are overlooked or ignored,
serious personal injury may occur.
The Model H0599 was specifically
designed for cutting and boring
holes. Do not modify and/or use this
machine for any other purpose.
Modifications or improper use of
this tool will void the warranty. If you
are confused about any aspect of
this machine, DO NOT use it until
you have answered all your ques-
tions. Serious personal injury may
occur.
First review the contents of your cordless
tool kit and familiarize yourself with the key
components.
Heavy-Duty Case
Cordless Cutting Tool
Depth Gauge
Open End Wrench
1 Hour Charger
1
⁄8" and
1
⁄4" Collets
The battery in your new cordless power
tool will not be fully charged when you
receive it. To maximize the storage capac-
ity of the battery it should be completely
discharged, then fully recharged 3-5 times.
For optimal life span, completely discharge
the battery before recharging.
Battery charging with the 1 hour
“Smart” charger (1 piece charger):
1. Plug the charger into an appropriate
110/120V outlet.
2. Insert the battery into the charger.
The battery fits into the oval recess
only one way. Do not force the bat-
tery. Insert until it locks into place.
3. The green light over the word “OFF”
on the control panel should come on.
If it doesn’t, make certain the wall out-
let you are plugged into is working. If
the outlet power is okay, the fuse
inside the charger may have blown.
Fuses should be replaced by a quali-
fied electrical technician.
4. To begin charging, press the “SET”
button. A steady red light over the
word “ON” should come on indicating
the battery is being charged.
5. When the battery is fully charged, the
red light will go off and the unit will
stop charging. Remove the battery
from the charger upon completion of
the charge cycle.
Inserting Battery Into cutter
1. Insert the battery into the handle of
the cutter. The battery will only install
in one orientation.