Grizzly H0627 Saw User Manual


  Open as PDF
of 1
 

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

MODEL H0627/H0628/H4231
ZERO-CLEARANCE
TABLE INSERT
INSTRUCTIONS
If you need help with your new insert, call our Tech Support at: (570) 546-9663.
Important Considerations
CARBIDE BLADES:

DEDICATED INSERTS:    




SPLITTER/RIVING KNIFE:


    

FINGER HOLE:     
         



DADO BLADE:     
    


Installing and Fitting Your Insert
1. 
2. 



3. 





4. 

Cutting the Blade Slot (Kerf)
1. 
        
       

2.          



3.       

      
 on 


4.        off
       

Note: Under certain conditions, an undesirable
scraping noise may be generated by excessive
arbor run-out or blade distortion causing the blade
body to intermittently contact the insert slot. To
remedy this, remove the insert and slightly widen
the slot, using a file or sanding paddle.
• Disconnectsawfrompowerbeforefitting
orremovingtableinsert!
• Alwaysweareyeprotection.
• Donottiltthebladewhileitisintheinsert!
Forbeveledcuts,aseparateinsertmust
beusedwiththebladeslot(kerf)cutonly
at that angle.
• Insert must be securely clamped down
with a board before plunging the blade
upthroughittocutthekerf.
• If using a blade stabilizer, check the
clearancebeforeraisingtheblade.