Filter
Top Products
Table Tilt
To tilt the table:
1.
2.
Figure 9
To adjust the 0° Stop:
1.
2.
Figure 11
Figure 9. Table lock lever.
notice
The table lock lever
can be repositioned by
pulling out on the
handle and rotating the
lever. This allows the
lever to rotate when
clearance is limited.
3.
Figure 10
Sanding Belt
Table
Gap <
1
⁄16"
Platen
Machine Base
Figure 10. Table gap.
A large gap between the belt and table pres-
ents a pinch point that could cause your
fingers to be pulled into the machine. Make
sure the gap between the sanding belt and
the table is less than
1
⁄16" to reduce the risk
of personal injury.
0° Stop Adjustment
Figure 11. Adjusting 0° stop.
3.