Filter
Top Products
H5571 34˚ Framing Nailer Kit-6-
OPERATION
Loading Nailer
To load your nailer:
1. Disconnect the air supply from the
nailer!
2. Pull the magazine pusher all the way
back until it locks in place.
3. Place a stick of nails into the maga-
zine as shown in Figure 2. Make sure
the pointed ends of the nails are fac-
ing down.
3. Slide the stick of nails all the way
down to the nose of the nailer.
4. Pull the magazine pusher all the way
back, release the catch lever, then let
it come forward until it rests against
the nail stick.
Figure 2. Loading the nailer.
When choosing nails for your Model
H5571, follow these guidelines:
Diameter: 0.113" - 0.162"
Length: 2"-3
1
⁄2"
Capacity: 50 Nails
Oiling Nailer
Special oil has been included with your
new Grizzly nailer to help maintain its use-
ful life. Place one drop of oil in the nailer air
inlet (as shown in Figure 1) before every
use. Wipe off any excess oil near the nail-
er exhaust to avoid dust build-up. When
the oil that was included with the nailer has
been completely used, replace with Grizzly
Model G2820 Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compressor
line. If your air compressor line already has
a lubricator, then regular lubrication of your
nailer will not be necessary. Just make
sure there is always oil in the lubricator.
As mentioned before, the best option is to
install a filter/lubricator/regulator unit avail-
able in the Grizzly catalog.
Figure 1. Lubricating nailer via air inlet.