Filter
Top Products
H6143 16 Ga. Finish Nailer
-8-
OPERATIONS
Loading
Figure 3. Sliding magazine pusher back
and engaging catch lever.
When replacing nails in your Model
H6143, follow these guidelines:
Gauge: 16
Length: 1
1
⁄4" – 2
1
⁄2"
Capacity: 74
To load your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Grip the nailer firmly, and pull the
magazine pusher back until the catch
lever engages, as shown in Figure 3.
Figure 4. Loading nails into magazine.
3. Insert a strip of nails, pointed-end
down, into the magazine as shown in
Figure 4.
Operating
If you have not read the safety instruc-
tions in this manual, do not operate
the nailer.
Before you operate your nailer, place five
to six drops of the included oil into the
quick connect fitting where the nailer con-
nects to the air supply.
To operate your nailer:
1. Connect the air supply to the quick
connect fitting.
2. To test for proper nail penetration, hold
the nailer perpendicular to the surface
of a piece of clean scrap wood that is
thick enough for the length of nails you
have loaded.
4. Slide the nails all the way down to the
nose of the nailer.
5. Release the magazine pusher by pull-
ing back on the pusher and pushing in
on the catch lever.
Pusher
Catch
Lever