Filter
Top Products
H6144 34° Angle Finish Nailer–2½"
-7--7-
Compressed Air
System
The Model H6144 is designed to be oper-
ated at 60-100 PSI using clean, dry, regu-
lated, compressed air. DO NOT exceed
the maximum operating pressure for
your model.
Before using your new nailer, install a
1
⁄4" NPT male quick connect fitting (not
included) on the nailer and a matching
1
⁄4" NPT female fitting (not included) on
the air hose. Regulate the air pressure on
your air compressor to the minimum PSI
for your model.
An in-line filter/lubricator/regulator unit,
shown in Figure 2, can be installed and
should be located as close to the H6144
as possible.
This filter/lubricator/regulator unit will
protect your tool from damaging water
build-up, allow you to adjust and maintain
constant air pressure to your tool, and
save you the inconvenience of having to
manually lubricate your tool every time
you use it.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector
Oiler
Filter
Regulator
Air
Compressor
Nailer
Figure 2 . Filter/Lubricator/Regulator Unit.
Check the current Grizzly catalog for avail-
ability of this unit. If you plan on install-
ing a filter/lubricator/regulator unit in your
compressed air system, always follow the
connection instructions that come with
the unit.
Exceeding the maximum permissible
operating pressure may cause the
nailer to explode, blowing metal frag-
ments in all directions. To protect
yourself from serious personal injury,
DO NOT allow your air compressor to
exceed the recommended pressure
when connected to this nailer!