Filter
Top Products
H6145 28° Clipped Head Framing Nailer
-10-
A jammed nail must be cleared before
using the nailer again. The two places
where a nail can get jammed are the maga-
zine and the discharge area.
To clear a jammed nail from the maga-
zine:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Pull back and lock the magazine push-
er.
3. Remove the nail stick.
4. Locate and remove the jammed nail
with needle nose pliers. Release the
catch lever and let the pusher slide to
front of the magazine.
To clear a jammed nail from the dis-
charge area:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Pull back and lock the magazine push-
er in place.
3. Remove all nails from the magazine.
4. Locate the nail in the nailer nose, dis-
lodge the nail with a tool that will fit in
the slot on the underside of the nose.
5. Throw the damaged nail away and
insert a new nail stick that only con-
tains clean, undamaged nails. DO
NOT use dirty or damaged nails!
6. Release the catch lever and let the
pusher slide to the front of the maga-
zine.
Clearing Jammed
Nails
Single/Bump Fire
Mode
The nailer is designed to fire one nail at a
time, or one after another, using the safety
yoke mechanism.
To operate your nailer in single fire
mode:
1. Depress the safety yoke mechanism
against the workpiece.
2. Pull the trigger, then remove your finger
from the trigger after the nail is driven.
To operate your nailer in bump fire
mode:
1. Pull the trigger.
2. Press the safety yoke mechanism
against your workpiece and raise it
after the nail is driven.
3. Hold the trigger and repeat Step 2 to
drive more nails.