Filter
Top Products
H7665 21° Round Head Framing Nailer
-10-
A jammed nail must be cleared before
using the nailer again.
To clear a jammed nail from the dis-
charge area:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Pull the magazine handle all the way
back until it latches.
3. Remove the nail stick from the maga-
zine.
4. Locate the opening in the underside of
the nailer nose (Figure 7).
5. Dislodge the jammed nail with a tool
that will fit in the slot on the underside
of the nose, such as needle nose pli-
ers.
6. Throw the damaged nail away and
insert a new nail stick that only con-
tains clean, undamaged nails. DO
NOT use dirty or damaged nails!
Clearing Jammed
Nails
Figure 7. Nose opening for clearing jams.
Nose Opening
Figure 6. Depth adjustment controls.
A depth adjustment device is attached to
the nose for setting the nail depth.
To adjust the dep
th:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Loosen the cap screw on the depth
adjustment device (Figure 6), and
move the safety nose backward to
increase the nail depth or forward to
decrease the nail depth.
Adjusting Depth
3. Connect nailer to the air supply, test
the nail depth, and repeat this entire
procedure if necessary until the nail
depth is satisfactory.
Safety Nose
Adjustment
Device