Filter
Top Products
Model H7669 HVLP Spray Gun -9-
1. Fluid Control: Controls the volume of
material that travels through the fluid
tip.
2. Pattern Control: Adjusts the spray
pattern from a round pattern to a wide
fan.
3. Air Flow Control: Controls the fluid
pressure inside the spray gun.
4. Atomizing Cap: Controls the spray
pattern from vertical to horizontal.
5. Trigger: Two stage trigger. Stage
one only releases compressed air for
blowing off the work piece. Stage two
sprays material.
6. Cup: 600 ml plastic cup allows easy
viewing of material level. Includes a
vented cap.
7. Regulator/Gauge: Regulates inlet
air pressure to the spray gun. It can
be attached directly to the gun for on-
the-spot air adjustments or directly
from the air source.
Note: DO NOT attach to an unregulat-
ed air source that exceeds 120 PSI.
Figure 2. Installing filter.
Figure 3. Controls.
2.
Screw the cup onto the top of the
body.
3. Attach the air hose to the spray gun
with a
1
⁄4" NPS quick connect set-up
(not included).
Note: You have the option of attach-
ing the regulator/guage directly to the
gun as shown in the photos. Some
may find this awkward and would rath-
er mount the regulator/gauge closer
to the air source.
4. Attach the spray gun to an air hose
regulated between 29 and 50 PSI.
Note: For the best results, use a hose
that will be dedicated for spray use
only. Do not use a hose that has been
used with an in-line oiler or other pos-
sible contaminant.
If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.
ControlsAssembly
1. Insert the filter into the gun body (see
Figure 2).
Cup
Fluid Control
Pattern Control
Atomizing Cap
Trigger
Regulator/Gauge
Air Flow Control