Filter
Top Products
H7679 2" Nailer Kit
-8-
OPERATIONS
Loading
Figure 3. Sliding magazine pusher back
and locking catch lever in place.
When replacing nails in your Model
H7679, follow these guidelines:
Gauge: 18
Length:
3
⁄8" – 2"
Capacity: 100
To load your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Sliding magazine pusher back, as
shown in Figure 3, to lock the catch
lever in place.
Figure 4. Loading nails into magazine.
3. Insert a strip of nails, pointed-end
down, into the magazine as shown in
Figure 4.
Operating
If you have not read the safety instruc-
tions in this manual, do not operate
the nailer.
Before you operate your nailer, place five
to six drops of the included oil into the
quick connect fitting where the nailer con-
nects to the air supply.
To operate your nailer:
1. Connect the air supply to the quick
connect fitting.
2. To test for proper nail penetration, hold
the nailer perpendicular to the surface
of a piece of clean scrap wood that is
thick enough for the length of nails you
have loaded.
4. Slide the nails all the way down to the
nose of the nailer.
5. Push the magazine pusher all the way
in until the catch lever locks.
Catch
Lever