Filter
Top Products
H7947/H7948 16 Gauge Stapler
-11-
A jammed staple must be cleared before
the stapler is used again.
To clear a jammed staple from the dis-
charge area:
1. DISCONNECT STAPLER FROM THE
AIR SUPPLY!
Clearing Jammed
Staples
Figure 10. Unlatching the nose cover.
3. Open the nose cover as shown in
Figure 11.
Figure 11. Opening the nose cover.
Nose Cover Latch
— If you want to increase the staple
depth, then move the adjust-
ing block up, toward the nose as
shown in Figure 9.
4. Tighten the depth adjustment cap
screw.
5. Connect the stapler to the air supply,
test the staple depth, and repeat this
entire procedure if necessary until the
staple depth is satisfactory.
Figure 9. Moving the adjustment block up.
Adjusting Block
Up
4. Grab the jammed staple with a pair of
pliers and remove it from the nose as
shown in Figure 12.
Figure 12. Removing a jammed staple.
Nose Cover
5. Close and latch the nose cover.
2. Unlatch the nose cover as shown in
Figure 10.