Filter
Top Products
H7947/H7948 16 Gauge Stapler
-6-
Compressed Air
System
The Model H7947/H7948 is designed to
be operated at 70–110 PSI using clean,
dry, regulated, compressed air. DO NOT
exceed 120 PSI.
An in-line filter/lubricator/regulator unit,
depicted in Figure 2, can be installed and
should be located as close to the stapler
as possible.
This filter/lubricator/regulator unit will pro-
tect your tool from damaging water build-
up, allow you to adjust and maintain con-
stant air pressure to your tool, and save
you the inconvenience of manually lubri-
cating your tool every time you use it.
Quick
Connector
Quick
Coupler
Air Hose
Quick
Coupler
Quick
Connector
Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2. Typical filter/lubricator/regulator installation order.
Check the current Grizzly catalog for avail-
ability of this unit. If you plan on install-
ing a filter/lubricator/regulator unit in your
compressed air system, always follow the
connection instructions that come with
the unit.
Exceeding the maximum permissible
operating pressure may damage the
seals, gaskets and hammer mecha-
nism of your stapler. DO NOT allow
your air compressor to exceed the
recommended pressure when con-
nected to this stapler or serious per-
sonal injury may result!