Filter
Top Products
H7949/H7950/H7951 Nailer
-9-
5. Put the first nail into the driving hole
and the second nail between the two
pawls of the feeder as shown in Figure
6.
Figure 6. Putting the nails in firing
position.
Feeder
Pawls
6. Close and latch the magazine cover.
Model H7951
Loading Nails
Use nails meeting the specifications listed
for your nailer on Page 4 of this manual.
To load nails in your nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
Point the nailer away from you and
others when connecting the air supply.
The nailer can cycle and discharge a
nail when the air supply is connected.
Ignoring this warning may result in
serious personal injury.
2. Unlatch the cover lock, as shown in
Figure 7, and pull the magazine cover
open.
Figure 7. Unlatching the magazine cover
lock: Model H7951.
Magazine
Cover Lock
Figure 8. Positioning the magazine plate.
Magazine
Plate
Adjusting
Pin
Nail Length
Marks
3. Press the adjusting pin inside the mag-
azine and slide the plate up or down
until the plate position matches the nail
length (Figure 8).
4. Place a coil of nails in the magazine,
position the first nail in the pawls of
the feeder as shown in Figure 9, then
close and latch the magazine cover.
Figure 9. Putting the nails in firing
position.
5. Close and latch the magazine cover.
Feeder
Pawls