Filter
Top Products
H7949/H7950/H7951 Nailer
-12-
A jammed nail must be cleared before the
nailer is used again.
To clear a jammed nail from the dis-
charge area:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Remove all nails from the magazine.
3. Use a steel rod and hammer to tap the
jammed nail back into the magazine
driving hole as shown in Figure 13.
Clearing Jammed
Nails
Figure 13. Tapping a jammed nail back
into the magazine driving hole.
Figure 12. Depth adjustment knob.
Adjusting Depth
To adjust the nail depth:
Adjusting the depth of nail penetration is
done by turning the adjustment knob locat-
ed near the trigger as shown in Figure 12.
4. Use a screwdriver to pry the jammed
nail out of the driving hole as shown in
Figure 14.
Depth Adjustment
Knob
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Turn the depth adjustment knob to
increase or decrease nail penetration:
— If you want to increase the nail
depth, then turn the adjusting knob
counterclockwise.
— If you want to decrease the nail
depth, then turn the adjusting knob
clockwise.
3. Connect the nailer to the air supply,
test the nail depth, and repeat this
entire procedure if necessary until the
nail depth is satisfactory.
Figure 14. Prying a jammed nail from the
driving hole.
Jammed Nail