Filter
Top Products
Model H8208 50-Piece Air Tool Set-6-
Impact Wrench
Your new single hammer
1
⁄2" drive impact
wrench (Figure 1) will generate up to 230
ft/lbs. of torque.
Only use thick-walled impact sockets with
this air tool. The common thin-walled
chrome sockets may explode if used as
impact sockets causing serious injury.
At the end of the handle you can adjust
the torque setting by pushing the knob in
and turning the knob to 1, 2, 3, or 4; 1 is
the lowest torque setting.
To change the impact rotation, push the
slide button toward the front of the gun
for clockwise rotation and to the rear for
counterclockwise rotation.
Air Hammer
Your new air hammer (Figure 1) is a great
tool for chipping and chiseling welds,
stone, wood, tiles, grout and many other
materials. But remember, never change
chisels with the air hammer still connected
to the air supply.
Before your first use, position the chisel
retaining spring onto the end of the air
hammer by threading it on in a clockwise
rotation until the retainer is completely
seated and it stops.
Three of the most common chisels are
included in this set. To install and remove
a chisel, push the chisel retaining spring
tang (Figure 3), so the retainer spring "U"
clears the chisel retaining shoulder and
insert or remove a chisel of your choice.
Note: If you have difficultly bending the
retainer spring to fit the bit, loosen or
remove the spring and insert the bit into
the spring prior to threading it on the
hammer.
Blowgun
The blowgun has a variety of tips and
adapters (Figure 1). Always disconnect
the blowgun from air before changing
tips. The blowgun safety tip has two holes
in the side to help prevent high pressure
air injection injuries if the blowgun is
accidently pushed against the skin. The
air is intended to exhaust out of the two
holes in the sides of the adapter and not
into your skin, helping to prevent severe
air embolism injury.
The other tips and adapters are intended
for high pressure use where side leakage
is not wanted. The jet tip directs a high
velocity jet of air to a pinpoint location, the
brass-barbed push-on hose tip connects
your blowgun to rubber hoses of various
size. To check for leaks where the port is
just a drilled hole, use the direct pressure
adapter with the rubberized tip that seals
the port of the system being pressurized.
To fill a soccer ball for example, you would
also use this adapter but with the ball
inflator tip. Never over-inflate any ball, or it
can explode causing severe injury.
Figure 3. Chisel installation.
Chisel Retaining Spring Tang