Filter
Top Products
-12- G8027 1 HP Dust Collector
Components and Hardware Needed: Qty
Motor/Impeller Housing ......................................1
Collector .............................................................1
Base ...................................................................1
Rubber Gasket ...................................................
1
Swivel Casters ....................................................
4
Collection Bag Support Rods ............................
2
Upper Bag Support
Rod .....................................1
Impeller Housing Support ...................................
1
Hex Bolts M6-1 x 15 .........................................
6
Hex Bolts M8-1.25 x 15 ......................................
8
Hex Nuts M5-.8 ................................................
18
Hex Nuts M8-1.25 ..............................................
4
Flat Washers 5mm ...........................................
22
Flat Washers 8mm ...........................................
12
Phillips Head Screws M5-.8 x 15 ......................
6
Phillips Head Screws M5-.8 x 10 .................... 16
Phillips Head Screws M4-.7 x 8 ........................
2
To assemble the dust collector base:
1. Make sure the dust collector motor is
unplugged!
2. Install the swivel casters onto the base with
sixteen M5-.8 x 10 Phillips head screws,
nuts, and flat washers (see
Figure 5).
Figure 5. Installing casters.
Figure 7.
Installing motor/impeller housing on
collector support.
Base and Supports
Figure 6. Installing collector support.
3. Place the base right side up and install the
collector support (
Figure 6) using four M8-
1.25 x 15 hex bolts and four flat washers.
4. Place the motor/impeller housing onto the
collector support plate and fasten with four
M8-1.25 x 15 hex bolts, four hex nuts, and
eight flat washers as shown in
Figure 7.