Filter
Top Products
G8592 3.6V Cordless Screwdriver/Flashlight -9-
Maintenance
Your cordless power tool will give you hun-
dreds of hours of operation time before
ever needing service. The electrical com-
ponents of this cordless drill are not user
serviceable. Repair should always be
undertaken by a qualified electrical repair
technician.
Keep the drill free from dirt and grease.
Always store it in a dry place, preferably in
the case that is supplied.
The battery will require periodic recharg-
ing, and eventually replacement after it has
exceeded its recharge life (approximately
800-1000 recharge cycles). You will notice
extended charging times or shortened
operation time as the battery experiences
more cycles. Battery must be recycled or
disposed of properly. Refer to the Grizzly
catalog for replacement batteries.
OPERATING TIPS AND MAINTENANCE
Disassembly and improper reassem-
bly of this device can result in electri-
cal shock danger. Always have this
device serviced by an qualified elec-
trical repair technician. Serious injury
will result.
Operating Guides and Tips
Avoid overloading the driver. Always
use a driver which matches the fas-
tener you are trying to drive. Do not
apply excessive pressure to the dri-
ver while using. If the speed drops
abnormally, decrease pressure
immediately. If the driver stops
abruptly or becomes blocked,
release the switch at once.
Ensure the safety of the workplace.
Clear the work area of all parts and
debris that may cause injury by flying
objects. Securely fix the object to be
fastened in a vise or otherwise clamp
to avoid injury. Do not attempt to hold
workpiece by hand.
Inspect the driver before use. Run the
driver before using to ensure all parts
are running smoothly and there are
no abnormal sounds or sparks. If any
defect is found, have unit serviced.
Know your worksite. Before driving fas-
teners, check behind walls for wires,
other electrical hazards, or plumbing.
Use accessories properly. Use the low-
est possible torque setting when dri-
ving fasteners. This will increase the
life span of the driving bit and pre-
vent damage to the fastener.