Filter
Top Products
Model T10828 (Mfd. since 12/14) -7-
Connecting Power
Power Connection
After you have completed all previous
setup instructions, the machine is ready to
be connected to the power supply.
To avoid unexpected startups or property
damage, use the following steps whenever
connecting or disconnecting the machine.
1. Turn machine power switch OFF.
2. Insert power cord plug into a matching
power supply receptacle. Tool is now
connected to power source.
Figure 3. Connecting power.
To test run machine:
1. Clear all setup tools away from
machine.
2. Remove collet nut and collet.
3. Set variable-speed knob to lowest set-
ting.
4. Connect machine to power supply.
5. Turn machine ON, verify motor opera-
tion, and then turn machine OFF.
Tool should run smoothly and without
unusual problems or noises.
Test Run
Serious injury or death can result
from using this machine BEFORE
understanding its controls and
related safety information. DO NOT
operate, or allow others to oper-
ate, machine until the information is
understood.
1. Turn machine power switch OFF.
2. Grasp molded plug and pull it com-
pletely out of receptacle. Do not pull
by the cord as this may damage wires
inside.
Disconnecting Power
Figure 4. Disconnecting power.