Filter
Top Products
-2-
T26902 14-Drawer Tool Chest (Mfd. 08/14)
2. Remove bottom drawer (refer to Operation
for instructions).
3. Place unit on its top or side.
Tip: Use packaging material to protect paint
finish.
4. Attach each caster using four M8-1.25 x 25
hex bolts, 8mm lock washers, and 8mm flat
washers (see Figure 3).
Be sure swivel casters with brakes are
mounted on same side as handle and fixed
casters are mounted parallel with long sides
of cabinet.
Figure 4. Location of drawer locking tabs.
3. Pull drawer out.
4. Apply a thin layer of dry lubricant to drawer
slides.
5. To re-install, insert drawer runners into slides
and push drawer in until it stops. The lock-
ing tabs will automatically snap into place to
secure the drawer in the slides.
Left Locking Tab
Right Locking Tab
Figure 3. Caster installed.
5. Return tool cabinet to upright position.
Swivel
Caster
x 4
Locking Drawers
Use the included key to lock the drawers. Only
completely closed drawers will lock.
Removing & Installing Drawers
To remove and install drawers:
1. Fully extend drawer and remove contents.
2. Push left locking tab down and hold, then pull
right locking tab up and hold (see Figure 4).
The drawers can be removed and re-installed if
an object inside causes them not to fully close.
Maintenance
• Use soft, clean cloth, and standard cleaning
solution to remove grease, dirt, or oil. Do not
use solvents or flammable cleaning liquids.
• Lubricate drawer slides as needed with dry
lubricant.
• Use graphite to lubricate lock annually.