Filter
Top Products
-2-
T26903 14-Drawer Tool Chest (Mfd. 08/14)
2. Remove casters and hardware from bottom
drawer.
3. Remove bottom drawer (refer to Operation
for instructions).
4. Place unit on its top or side.
Tip: Use packaging material to protect paint
finish.
5. Attach each caster using four M8-1.25 x 25
hex bolts, 8mm lock washers, and 8mm flat
washers (see Figure 3).
Be sure swivel casters with brakes are mount-
ed on same side as handle, and fixed casters
are mounted in middle of unit, parallel with
long sides of cabinet.
Removing & Installing Drawers
Figure 3. Caster installed.
6. Return tool cabinet to upright position.
Swivel
Caster
x 4
Locking Drawers
Use the included key to lock the drawers. Only
completely closed drawers will lock.
To remove and install drawers:
1. Fully extend drawer and remove contents.
2. Push left locking tab down and hold, then pull
right locking tab up and hold (see Figure 4).
3. Pull drawer out to remove.
4. To re-install, insert drawer runners into slides
and push drawer in until it stops. The lock-
ing tabs will automatically snap into place to
secure the drawer in the slides.
Figure 4. Location of drawer locking tabs.
Right Locking Tab
Left Locking Tab
Maintenance
• Use soft, clean cloth, and standard cleaning
solution to remove grease, dirt, or oil. Do not
use solvents or flammable cleaning liquids.
• Lubricate drawer slides as needed with dry
lubricant.
• Use graphite to lubricate lock annually.
The drawers can be removed and re-installed if
an object inside causes them not to fully close.