Filter
Top Products
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 13
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram on page 14.
CAUTION: Always make sure the Power Cord of the Soldering Gun is unplugged from
its electrical outlet prior to making any adjustments to the tool.
WARNING: This product contains lead, which is a chemical known to the State of Cali-
fornia to cause cancer and birth defects or other reproductive harm. (California Health &
Safety Code 25249.5, et seq.)
This product, when used for soldering and similar applications, produces chemicals
known to the State of California to cause cancer and birth defects (or other reproductive
harm). (California Health & Safety Code 25249.5 et seq.)
SKU 04328 PAGE 10
Preparing the Soldering Tip
1. Using Wrench (16), check that the Soldering Tip Nuts (2) are not loose.
Do not overtighten as you may strip the threads.
2. Set the Soldering Gun on the workbench, and plug the Line Cord into an electrical
outlet.
3. Press on the Trigger Switch (12) until the Soldering Tip (1) heats up.
4. Apply a sufficient amount of rosin-core solder to melt over the entire tip of the
Soldering Gun. Wipe the tip with a rag until the tip is clean and shinny.
Solder Flux
Roll of
Solder
Soldering Tips
(1)
Wrench (16)
Soldering Gun