Filter
Top Products
3. With the dowel holes precisely drilled, it is easy to assemble the two boards together. Put glue in the
holes and on the dowels. Insert the dowels into the holes and tightly clamp the boards until glue has dried.
4. The Self Centering Doweling Jig can be used to make accurate butt joints, miter joints, and edge joints,
as well as acting as a mortising guide.
Parts Listing
Part # Description Qty Part # Description Qty
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A
REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTA-
TION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS
TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN
FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY
THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO
THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTAL-
LATION OF REPLACEMENT PARTS THERETO.
#41345 Page 3
Parts Diagram
1 Screw 2
2 Adjustment Nut 1
3 Washer 2
4 Rear Pressing Block 1
5 Screw Arbor 1
6 Bushing 6
7 Spring Screw 1
8 Spring 1
9 Steel Ball 1
10 Guide Block 1
11 Leading Shaft 2
12 Front Pressing Block 1
13 Handle 1
Note: There are 4
holes along the top of
the Jig. Only 2 of the
holes accept threaded
bushings. The other 2
holes accept 7/16” and
1/2” drill bits.
REV 08/04