Filter
Top Products
Page 11SKU 42864
For technical questions, please call 1-800-444-3353.
INSPECTION, MAINTENANCE, AND CLEANING
WARNING! Make sure the Power Switch (2) of the Sander is in its “OFF” posi-
tion and that the tool is unplugged from its electrical outlet before performing any
inspection, maintenance, or cleaning procedures.
BEFORE EACH USE, inspect the general condition of the Sander. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, dam-
aged electrical wiring, and any other condition that may affect its safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
Wipe the unit down after each use with a dry, lint free cloth.
Make sure the vents on the top are clear of dust and debris.
Periodically, have a qualified service technician clean or replace the Carbon Brushes
(4).
1.
2.
3.
4.
5.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE
IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES
ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF RE-
PLACEMENT PARTS THERETO.
PARTS LIST
Part Description
1 Right Housing
2 Switch
3 Carbon Brush Spring
4 Carbon Brush
5 Pedestal Bearing
6 Circuit Board
7 Electric Cord
8 Cord Protector
9 Power Cord Holder
10 Screw
11 Label
Part Description
12 Dust Chute Gasket
13 Left Housing
14 Stator
15 Backing Pad
16 Armature
17 Base Plate
18 Tapered Sleeve
19 Dust Chute
20 Dust Port
21 Screw