Filter
Top Products
7. Use eye and ear protection. Always wear ANSI approved impact safety
goggles. Wear an ANSI approved face shield when producing metal filings.
8. Do not overreach. Keep proper footing and balance at all times. Do not
reach over or across electrical cables or frames.
9. Maintain tools with care. Inspect tool cords periodically and, if damaged,
have them repaired by an authorized technician.
10. Use the right tool for the job. Do not attempt to force a small tool or
attachment to do the work of a larger industrial tool. There are certain
applications for which this tool was designed. Do not modify this tool and do
not use this tool for a purpose for which it was not intended.
11. Stay alert. Watch what you are doing, use common sense. Do not operate
any tool when you are tired.
12. Check for damaged parts. Before using any tool, any part that appears
damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment and binding
of moving parts; any broken parts or mounting fixtures; and any other
condition that may affect proper operation. Any part that is damaged should
be properly repaired or replaced by a qualified technician. Do not use the tool
if any switch does not turn On and Off properly.
13. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use
accessories intended for use with this tool. Approved accessories are
available from Harbor Freight Tools.
14. Do not operate tool if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
15. Use proper size and type extension cord. If an extension cord is required,
it must be of the proper size and type to supply the correct current to the
tool. Otherwise, the extension cord could melt and catch fire, or cause
electrical damage to the tool. This tool requires use of an extension cord of 0
to 12 amps capability (up to 50 feet), with wire size rated at 14 AWG. Longer
extension cords require larger size wire. If you are using the tool outdoors,
use an extension cord rated for outdoor use. (signified by “WA” on the jacket).
16. Maintenance. For your safety, maintenance should be performed regularly
by a qualified technician.
Note: Performance of this tool (if powered by line voltage) may vary depending on
variations in local line voltage. Extension cord usage may also affect tool perfor-
mance.
SKU 44829 Page 3