Filter
Top Products
SKU 46365 Page 5
13. Do not use this tool if it is not loaded, as this will accelerate wear on the tool.
14. Be sure all hoses and fittings are free from damage and dirt. Replace any
part that does not appear to be operating properly.
Warning: People with pacemakers should consult with their physician(s)
before using this product; operation of equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
Warning: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
cur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by
the operator.
Unpacking
When unpacking, check to make sure all parts listed on Page 7 are included.
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Maintenance
1. Do not store the Stapler in cold or freezing temperatures. If you are
operating the Stapler in cold weather, use a permanent antifreeze as
lubricant. Certain drying agents may damage o-rings and seals, so be sure
to check these periodically.
2. It is recommended that you use an Oiler with this tool, especially if you use
this tool regularly. Be sure the check the oil level in the Oiler before each
use, and during prolonged periods of use.
3. If you are not using an Oiler, you must lubricate the Stapler before and after
each use. Be sure to disconnect the tool from the air supply if you are
lubricating it by hand. To lubricate this tool: add 5-6 drops of air tool
lubrication to the Air Inlet. Do not use detergent oil or oil adhesives. Run the
Stapler for a short time after lubrication and wipe off all excess oil.
4. A filter (not included) can be used to remove liquid and solid impurities which
may rust or block internal parts and mechanisms. Periodically check the
Filter and drain any water.