Filter
Top Products
SKU 46935 For technical questions, please call, 1-800-444-3353. Page 5
Operation
Installing a Chisel.
Chisels come with or without collars.
Figure 1
shows
installation of a chisel without a collar (the two included chisels
are without a collar).
Figure 2
shows installation of a chisel
with a collar.
Without a Collar:
1. Pull the retaining ring to the side just far enough to allow
the bit to be inserted, as shown in
Figure 1
.
2. Insert the bit. Slide the chisel in as far as it will go.
3. Pull the retaining ring down approximately 120° until it
contacts the housing. Physically check that the chisel is
secure before operating.
Note: If the Chisel Bit doesn’t slide in easily, apply some grease
on the loading end of the Chisel Bit.
Retaining
Ring
With a Collar:
1. Pull the retaining ring open about 30-40° to the second
engaging position as shown in
Figure 2
.
2. Insert the collared chisel.
3. Return the retaining ring to close to its original position
to lock the chisel in place. Physically check that the chisel
is secure before operating.
Before each use, check the Chisel for cracks or other dam-
age: Never use a damaged Chisel.
REV 11/03; REV 06/04
Figure 1
Make sure you only use sharp tipped chisels.
Dull tipped chisels can cause unnecessary
chisel movement resulting in tool wear, and
possible injury.
Retaining
Ring
Figure 2