Filter
Top Products
8. STAY ALERT. Watch what you are doing at all times. Use common sense. Do not use the
Air Angle Die Grinder when you are tired or distracted from the job at hand.
9. CHECK FOR DAMAGED PARTS. Before using the Air Angle Die Grinder, carefully check
that it will operate properly and perform its intended function. Check for damaged parts and
any other conditions that may affect the operation of the Air Angle Die Grinder. Replace or
repair damaged or worn parts immediately.
10. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical replace-
ment parts. Only use tools and accessories intended for use with this Air Angle Die Grinder.
Approved tools and accessories are available from Harbor Freight Tools.
11. MAINTAIN THESE PRODUCTS WITH CARE. Keep this tool and accessories clean and
dry for better and safer performance.
12. MAINTENANCE: For your safety, service and maintenance should be performed regularly
by a qualified technician.
13. USE THE RIGHT PRODUCTS FOR THE RIGHT JOB. There are certain applications for
which this Air Angle Die Grinder was designed. Do not use a small tool or accessory to do
the work of a larger industrial tool or accessory. Do not use this Air Angle Die Grinder for a
purpose for which it was not intended.
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
1. USE CLEAN, DRY, REGULATED COMPRESSED AIR AT 90 PSI. Do not exceed the
recommended 90 PSI. Never use oxygen, carbon dioxide, combustible gases or any other
bottled gas as a power source for this tool.
2. DO NOT MODIFY THE SAFETY AIR SHUT-OFF SWITCH LOCATED ON THE THROTTLE
LEVER (PART #2). The Air Angle Die Grinder features a Shut-Off Switch which, when
pressure is released from the Throttle Lever, will automatically shut down the unit. For your
safety and the safety of others, do not modify the Shut-Off Switch in any way.
3. WHEN CONNECTING TO THE AIR SUPPLY:
A. If an automatic oiler is not used, add two drops of air tool oil into the air inlet
of the Air Angle Die Grinder. (See Figure A.)
B. Turn on the compressor and set the regulator to the recommended 90 PSI for this tool.
4. ALWAYS DISCONNECT TOOL FROM ITS AIR SUPPLY AND RELEASE ALL BUILT UP
AIR PRESSURE BEFORE PERFORMING ANY SERVICES OR MAINTENANCE such as
cleaning or changing accessories on the Air Angle Die Grinder, leaving the work area,
moving the Air Angle Die Grinder from one location to another, handing the Air Angle Die
Grinder to another person, etcetera. (See Figure A on page 4.)
5. WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities, contain chemicals known (to the State of California) to cause cancer,
birth defects or other reproductive harm. Some examples of these chemicals are: lead from
lead-based paints, crystalline silica from bricks and cement or other masonry products,
arsenic and chromium from chemically treated lumber. Your risk from these exposures varies,
depending on how often you do this type of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and work with approved safety equipment, such as
those dust masks that are specially designed to filter out microscopic particles.
(California
Health & Safety Code § 25249.5, et seq.)
SKU 52848 PAGE 3
REV 02/06