Filter
Top Products
SKU 65930 For technical questions, please call 1-800-444-3353. PAGE 9
CHARGING
NOTE: The Battery Pack (28) requires charging before first use. The first charge 1.
requires a 5 hour charge prior to initial use of the Cordless Drill.
Note: Always switch to a fresh battery when tool performance begins to diminish. 2.
Severe heat is most destructive to a battery; the more heat generated, the faster
the battery loses power. A battery that gets too hot can be permanently damaged.
Never over-discharge a battery by using the tool after its’ performance is decreasing.
Never attempt to discharge a tool’s battery by continuing to pull the trigger. When
tool performance begins to diminish, stop the tool, recharge the battery and use
the fresh battery for optimal performance.
When the Battery Pack requires recharging, a 3. 3-5 hour charge allows the tool to
operate at full power.
Charging room temperature: 50° F. – 104° F.4.
Depress both buttons at the rear of each side of the Battery Pack and slide unit back 5.
to detach from the Drill. Plug Battery Pack into Adapter (30) the same way it plugs
into the Cordless Drill, then slide Adapter onto Charger (29), and plug the Charger
into the nearest 120 volt, grounded, electrical outlet.
While charging, the Battery Pack, Charger, and Adapter may become warm to the 6.
touch. This is normal, and does not indicate a problem.
Once the Battery Pack is fully charged, disconnect the Charger from the electrical 7.
outlet. Disconnect the Adapter and the Battery Pack from the Charger.