Filter
Top Products
Page 10SKU 66098 For technical questions, please call 1-800-444-3353.
leave the Heat Gun unattended while
pointed at surfaces or objects.
The Heat Gun can be used for:8.
Shrinking of shrink tubing, •
packaging and electrical
components.
Deforming of articles made from •
acrylic, PVC, and polystyrene
tubing, plates, and proles as well
as most woods.
Welding of thermoplastic polymer, •
ooring materials of PVC and
linoleum, PVC-coated fabric,
wallpaper, tarpaulins and foils.
Soldering of tin, special silver •
solder, SMD elements, cable
lugs, and for loosening soldered
connections.
Paint removal. Removal of old •
coatings of oil paint, varnish, and
synthetic plaster.
Drying of color shade samples, •
lter, adhesives, construction joints
and stucco forms.
Joining adhesives. Large surface •
gluing with contact adhesives,
activation of pressure, or heat
sensitive adhesives, acceleration
of bonding processes, releasing of
bonding points as well as releasing
or bonding of edge bond or veneer.
Defrosting of icy stairs and steps, •
door locks, trunk lids, car doors or
metal water pipes.
Disinfection. With the tool set at the •
highest setting, animal sites/stables
may be disinfected. Wood worm
infestation may be controlled. Do
not heat up the wood surface too
much or it can burn.
Never touch work
area with the Heat
Gun; it could scorch or ignite.
When the job is nished, move the 9.
Switch to the “COLD” setting and
allow the Heat Gun to cool down on
an insulated, non-ammable surface.
When the unit has cooled move the 10.
Switch to the “OFF” position.
Disconnect the power supply after 11.
use. Clean, then store the tool
indoors out of children’s reach.