Filter
Top Products
Page 5For technical questions, please call 1-800-444-3353.SKU 67708
Do not leave compressor unattended 5.
for an extended period while plugged
in. Unplug compressor after working.
Keep compressor well-ventilated. Do 6.
not cover compressor during use.
Drain Tank daily and after use. Internal 7.
rust causes tank failure and explosion.
Add correct amount of compressor 8.
oil before rst use and every use.
Operating with low or no oil causes
permanent damage and voids warranty.
Do not remove the valve cover or adjust 9.
internal components.
Compressor head gets hot during 10.
operation. Do not touch it or allow
children nearby during or immediately
following operation.
Do not use the air hose to move the 11.
compressor.
Release the pressure in the storage tank 12.
before moving.
The use of accessories or attachments 13.
not recommended by the manufacturer
may result in a risk of injury to persons.
All air line components, including hoses, 14.
pipe, connectors, lters, etc., must be
rated for a minimum working pressure
of 150 PSI, or 150% of the maximum
system pressure, whichever is greater.
USE OF AN EXTENSION CORD IS NOT 15.
RECOMMENDED. If you choose to
use an extension cord, use the following
guidelines:
RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS
(120 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25’ 50’ 100’ 150’
0 – 6 18 16 16 14
6.1 – 10 18 16 Do not use.
10.1 – 12 16 16 Do not use.
12.1 – 16 14 12 Do not use.
TABLE A
Make sure your extension cord is in a.
good condition.
Be sure to use an extension cord b.
which is heavy enough to carry the
current your product will draw. An
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. Table A shows the correct
size to use depending on cord length
and nameplate ampere rating. If in
doubt, use the next heavier gauge. The
smaller the gauge number, the heavier
the cord.
Industrial applications must follow OSHA 16.
guidelines.
Maintain labels and nameplates on the 17.
compressor. These carry important
safety information. If unreadable or
missing, contact Harbor Freight Tools for
a replacement.
This product is not a toy. Keep it out of 18.
reach of children.
Operate unit on level surface. Check 19.
oil level daily and ll to marked level if
needed.