Filter
Top Products
Page 10 For technical questions, please call 1-800-444-3353. SKU 68298
Maintenance and Servicing
Procedures not specically explained
in this manual must be performed
only by a qualied technician.
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the
tool from its electrical outlet before performing any
inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal
noise or vibration occurs, have the problem
corrected before further use.
Cleaning, Maintenance,
and Lubrication
1. BEFORE EACH USE, inspect general condition
of tool. Check for loose screws, misalignment or
binding of moving parts, cracked, bent or broken
parts, damaged electrical wiring, and any other
condition that may affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
3. After regular intensive use, the Carbon Brushes (22)
may need to be replaced. NOTE: The Tile Saw’s motor
will not function once the Carbon Brushes
wears down.
4. To replace the Carbon Brush (22):
a. Use a screwdriver to open Carbon
Brush Covers (21).
b. Then remove the Carbon Brushes Holder
(8) and slide out Carbon Brush.
c. Replace with new Carbon Brush, slide
Carbon Brush Holder back into housing,
and replace Carbon Brush Cover.
5. WARNING! If supply cord of power
tool is damaged, it must be replaced only
by a qualied service technician.