Filter
Top Products
Page 7For technical questions, please call 1-800-444-3353.Item 69054
12. Once the ends of the Lower Support have been fastened to
the Legs, use the Screws (6) to fasten the middle of the
Lower Support to the top of the Sliding Partition.
See Figure L, right.
13. With assistance, set the assembled frame right-side up and
in the spot where you want the Workbench located.
14. Remove the Vise Screw and Washer (12) from the middle
thread of the Vise (5). See Figure M, right.
15. Once the Vise Screw and Washer are removed, slide the
Vise into the three holes on the side of the Workbench.
Once the Vise is threaded into the holes halfway, use the
Hex Wrench to tighten the screws on either side of the
Vise’s center thread. See Figure N, right.
16. Use the Vise handle to thread in the Vise all the way and re-
install the Vise Screw and Washer. This will keep the Vise
locked on place on the side of the Workbench.
Lower
Support
(15)
Sliding
Partition (14)
Figure L
Figure M
Vise (5)
Vise Screw/
Washer
(12)
Figure N
Hex
Wrench
(3)
Vise (5)
SAFETYOPERATIONMAINTENANCE SETUP