Filter
Top Products
Page 10 For technical questions, please call 1-800-444-3353. Item 69342
Troubleshooting
Problem Possible Causes Likely Solutions
Heat Gun will
not turn on.
1. Cord not connected.
2. No power at outlet.
3. Power Switch set at “0”.
4. Internal damage or wear.
(Switch, for example.)
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker. If breaker
is tripped, make sure circuit is right capacity
for tool and circuit has no other loads.
3. Turn Power Switch to “I” or “II”.
4. Have technician service tool.
Unsatisfactory
results.
1. Inappropriate heat for task. 1. Adjust heat setting or distance to
workpiece to compensate.
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power
supply before service.
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet
before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
3.
WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
SAFETY OPERATION MAINTENANCESETUP