Filter
Top Products
6. Adjust the flame to the desired level by turning the Hand Wheel (6)
counterclockwise
. (See Figure A.)
7.
NOTE: The lit Propane Torch should operate with a blue flame with a small
yellow tip. If necessary, adjust the Hand Wheel (6) if there is sputtering or
popping. (See Figure A.)
8. Pressing the Lever (19) down toward the Handle (11) will intensify the size of the
flame. Releasing the Lever will bring the flame back to its previous size.
(See Figure A.) Caution: Be extra careful when using the Propane Torch with
the intense flame.
9. To extinguish the flame, close the Hand Wheel (6) by turning it completely
clock-
wise
. (See Figure A.)
10. Allow sufficient time for the Propane Torch to completely cool. Then, store the
Propane Torch in a safe location and out of reach of children.
11. Disconnect the torch from the LP cylinder when not in use. Protect the hose from
cuts and abrasions.
INSPECTION, MAINTENANCE, AND CLEANING
1. Before each use, inspect the general condition of the Propane Torch. Check the
Propane Torch for loose connections and joints, cracked, bent, or broken parts,
damaged hose, damaged propane tank, and any other condition that may affect
the safe operation of the Propane Torch. If a problem occurs, have the problem
corrected before further use. Do not use damaged equipment.
2. When cleaning, use only water and a mild detergent. Do not use cleaners that
are combustible or corrosive.
3. When storing, always allow sufficient time for the Propane Torch to completely
cool down before storing. Do not store flammable liquids or materials in the area
surrounding the Propane Torch. Make sure the Propane Torch’s Hand Wheel (6)
is in its “OFF” position. Only store the Propane Torch in a location that is out of
reach of children.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTUER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PROD-
UCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
SKU 91033 PAGE 7