Filter
Top Products
Page 6SKU 91715 For technical questions, please call 1-800-444-3353
Air Inlet (408)
Forward/Reverse
Lever (205)
Trigger (409)
Anvil (105)
FIGURE 1
FIGURE 2 FIGURE 3
ForwardReverse
Turn the Forward/Reverse Lever (205) all the way
clockwise for high speed forward.
Turn it so that it points straight up and down for
low speed forward (shown above).
Turn it all the way counterclockwise for reverse.
Grease
Fitting
(410)
1. Make sure your Impact Wrench is disconnected from the air hose before attempting
any maintenance.
2. Wipe the Impact Wrench down with a lint free cloth after each use.
3. Make sure the Anvil (105) is clear of dirt or debris. If possible, spray it with compressed
air before each use.
4. Annually, or more often if used on a daily basis, use a grease gun (not included), to
inject grease into the Grease Fitting (410). See FIGURE 3 on page 6.
5. If you do not use an inline oiler/filter system, lubricate the tool daily by holding it so that
the Air Inlet (408) is facing up. Squeeze the Trigger (409), and place one or two drops of
oil into the Air Inlet (408). Squeezing the Trigger (409) allows the oil to circulate in the
motor.
Maintenance
REV 03/05