Filter
Top Products
SKU 91939 Page 4
Unpacking
When unpacking, please compare with parts list to be sure that all parts are included.
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Assembly
1. Install all three Base Bolts (F) into the Base
(E) approximately 1/2 way. These bolts will be used
to level the Balancer on your floor. NOTE: For best
results, you should use the Balancer on a hard
level surface, such as a cement garage floor.
2. Thread one of the Nuts (D) approximately
2” up the Shaft (B). Insert the Shaft (B) through
the hole in the Base (E) as in the assembly diagram.
Thread the second Nut (D) onto the shaft, and
tighten to lock the Shaft (B) onto the Base (E).
3. Place the Hub Support (C) onto the
Shaft (B).
4. Place the Bubble Level (A) onto the
top of the Hub Support (C).
5. Level the Wheel Balancer relative to your
floor by adjusting the Base Bolts (F) up
or down, until the bubble in the Bubble
Level (A) is centered in the bullseye
marked in the center of the level.