Filter
Top Products
Page 6SKU 92421 For technical questions, please call 1-800-444-3353
Operation (continued)
Refer to FIGURES 2 and 3 on page 5, and the Assembly Drawing on page 9.
Note: Turn off your air compressor and disconnect the air hose when you are changing
sockets. After you attach the socket, attach the air hose and turn the air compressor
on.
1. Select the appropriate size 1” drive socket for your needs.
2. Push and snap the socket (not included) onto the Anvil (38).
3. To operate the Forward/Reverse Valve (17) follow the directions in FIGURE 4 below.
FIGURE 4
Forward
Reverse
The Forward/Reverse Valve (17) has
three forward and three reverse speeds.
Turn the Valve to the right toward the
clockwise arrow to tighten, and to the
left, toward the counterclockwise
arrow to loosen.
Handle
Tightening
Note: Set the Forward/Reverse Valve (17) so that the anvil turns clockwise (forward).
7. Tighten the nut as tight as you can by hand.
8. Place the socket (not included) over the nut you wish to tighten.
9. Grip the Impact Wrench firmly with two hands and gently squeeze the Trigger (13).
Note: If the Impact Wrench cannot tighten the nut to your satisfaction, do not raise the air
pressure on the compressor over 90 PSI. Pressures above 90 PSI will strip the work-
piece and damage the tool, potentially causing the tool to fail, causing serious injury.
Use other appropriate methods and tools to tighten the nut.
10. When the nut is tightened, release the Trigger (13). Turn off the air compressor and
disconnect the hose.
11. Always check the recommended torque specification for the nut. Use a torque
wrench to tighten the nut to the proper setting after using the Impact Wrench.
(Shown without protective coating for clarity.)