Filter
Top Products
Page 4SKU 92639 For technical questions, please call 1-800-444-3353
Operation
Cone Head (5)
Hook Head (8)
Round Head (7)
Wedge Head (6)
Slide (3)
Handle (4)
FIGURE 1
Hook Pulling
1. Identify the area you will be inserting the Hook Head (8) into or onto.
2. Back the Knurled Nut to the end of the Hook Head (8). Thread the Knurled Nut onto
the Shaft (1).
3. Place the Hook Head (8) tip onto the edge or lip of the object to be pulled.
4. Gripping the Handle (4) securely with one hand, and the Slide (3) with the other, firmly
pull the Slide (3) toward the Handle end of the Slide Hammer.
5. Repeat pulling the Slide (3) until the object has been pulled out.
Hammering (Pushing in dents)
1. Identify the area you will be hammering onto.
2. Depending on the shape of the metal you are hammering or pushing in, choose either
the Wedge (6), Round (7), or Cone (5) Head.
3. Thread the Head onto the Shaft (1).
4. Gripping the Handle (4) securely with one hand, and the Slide (3) with the other, firmly
push the Slide (3) toward the end of the Shaft (1) with the head (into the dent).
5. Repeat pushing the Slide (3) until the dent is pushed in.
The results achieved with this tool rely largely on the skill of the operator.
Harbor Freight Tools is not responsible for any damage caused by inexperience or
by misuse of this tool. Harbor Freight Tools recommends that this tool should be
used only by experienced auto body repair professionals.
Shaft (1)
Knurled Nut