Filter
Top Products
SKU 92849 Page 4
16. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use
accessories intended for use with this tool. Approved accessories are
available from Harbor Freight Tools.
17. Do not operate tool if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
18. Use proper size and type air pressure line and fittings. The recommended
air line for this tool is 3/8” delivering no more than 90 psi. Recommended air
inlet size is 1/4” - 18 npt.
19. Maintenance. For your safety, service and maintenance should be performed
regularly by a qualified technician.
20. You should maintain a proper regulator and moisture trap in your air
line at all times.
21. Use compressed air only. Never use combustible gas as a power source.
Note: Performance of this tool may vary depending on variations in local air pressure.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are factors
which cannot be built into this product, but must be supplied by the operator.
Air Pressure Supply
We recommend that you use both a filter and an in-line oiler in your air supply
system as illustrated in the diagram below. These components are not included
with this tool, abut are available from Harbor Freight Tools.
We recommend that you install a quick-release nipple (not included) into the Inlet
Connector (15). Quick release connectors at all points that a hose attaches to your
compressor set up and your tools make working with air powered tools easier and
more convenient.
Air Impact
Wrench