Filter
Top Products
SKU 93468 For technical questions, please call 1-800-444-3353 Page 4
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are fac-
tors which cannot be built into this product, but must be supplied by the opera-
tor.
Unpacking
When unpacking, check to make sure the following parts are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover
of this manual.
Operation
Warning: The vehicle engine must never be started in a closed garage, or any
other sealed structure. Carbon monoxide is produced during operation and is
deadly in a closed environment. Early signs of carbon monoxide poisoning
resemble the flu, with headaches, dizziness, or nausea. If you have any of these
signs get fresh air immediately.
1. Select the appropriate Oil Filter Cup by size specification of the oil filter, and
the number stamped on the Oil Filter Cup.
2. Snap in the 3/8” Socket Driver (15) into the bottom of the selected Oil Filter
Cup.
3. Snap in the other end of the 3/8” Socket Driver (15) into the 1/2” socket
wrench (not supplied).
4. Press the Oil Filter Cup over the Oil Filter
as far as it will go.
5. Place an oil pan, or other oil recovery
devise, under the oil filter to catch the
draining oil.
6. Turn socket wrench counterclockwise until oil filter is removed.
7. Install a new oil filter by first lubricating the new filter gasket, then hand-screw
the filter in place until tight.
Oil Filter Cups
3/8” Socket
Driver (15)